New service
On-site IT and networks, done by people who also write software.
Cabling, Wi-Fi, switching, firewalls and hardware - installed properly, documented, and supported by a local team you can actually get hold of.
Why we added this
Because we kept being asked.
Over the years the same conversation kept happening: we would build a system, and a month later someone would ring to say it was slow - which turned out to mean the Wi-Fi did not reach the far end of the unit, or everything was hanging off an unmanaged switch under a desk.
We could keep pointing people at someone else, or we could learn to do it properly. We chose the second one. The network is not a separate thing from the software - it is the thing the software runs on, and treating them as one job produces a better result than treating them as two.
So we now cable buildings, survey and install Wi-Fi, configure switches and firewalls, set up workstations and support all of it afterwards. Same company, same phone number, same people who know how your systems fit together.
What we install and support
From a single access point to a whole building.
Every job starts with a survey, ends with documentation, and never leaves you with a cabinet nobody understands.
Structured cabling
Cat6/Cat6a data cabling, patch panels, fibre runs and cabinet tidy-ups, tested before we leave.
More on structured cablingBusiness Wi-Fi
Surveyed, designed and installed wireless that covers the whole site, including yards and warehouses.
More on business Wi-FiSwitching, routing & firewalls
Managed switches, VLANs, VPNs and firewalls configured properly and documented before we leave.
Hardware & workstation setup
Procurement, imaging, rollouts and office moves. New starters ready on day one.
CCTV & door entry
IP camera systems and access control that sit on the network you already trust.
More on cCTV & door entryOngoing IT support
Remote and on-site support contracts with response times in writing. No 40-minute hold music.
More on ongoing IT supportStructured cabling, properly
Cable runs planned around how the building is actually used, terminated to standard and properly tested before we sign off. You get the test results, a labelled patch panel and a floor plan showing what goes where.
- Cat6 and Cat6a copper, fibre backbone where it is needed
- Cabinets, patch panels, containment and tidy-ups
- Every port labelled at both ends and recorded
- Test results handed over as a PDF
Wi-Fi that reaches the far corner
Most bad Wi-Fi is not a hardware problem, it is a design problem - too few access points in the wrong places, all fighting on the same channel. We survey first, then put the right kit where the survey says it should go.
- Predictive and on-site surveys before anything is bought
- Coverage for warehouses, yards and outbuildings
- Separate guest and staff networks, properly segmented
- Roaming that does not drop calls as you walk
How an install runs
You will know what is happening, and when.
No engineer turning up unannounced, no invoice with surprises on it.
-
1
Site survey
We walk the building, look at what is there, and ask how your team actually works. Free, and no obligation.
-
2
Written proposal
A schedule of works, a fixed price, and a clear note of anything that could change it.
-
3
Installation
Booked at a time that suits you, including evenings and weekends. We tidy up after ourselves.
-
4
Handover pack
Test results, labelled ports, network diagram, credentials handed over securely. It is yours, not ours.
Where we come out to
We are based in Redditch, so most of our on-site work is within about 45 minutes. For larger installs we travel further - travel is always quoted up front.
- Redditch
- Bromsgrove
- Alcester
- Studley
- Evesham
- Droitwich
- Worcester
- Solihull
- Birmingham
- Stratford-upon-Avon
Questions